AT20 Online Dual-spectrum Thermal Camera User Manual
9
6.
Quick Start Guide
1. After installing the thermal camera in the desired position, use the
cable to connect the thermal camera and the computer normally.
There are two power supply methods for AT20. Connect the device to
the PoE port of the power supply through the M12 8-pin adapter cable
or connect to the DC power supply through the M12 12-pin adapter
cable. Connect AT20 to the network, and wait for 2 minutes after
powering on. The power indicator light is steady blue and the network
indicator light flashes green, indicating that the network connection is
normal.
2. Modify the computer network segment to be the same with that of
thermal camera. The specific path is "Control Panel"-"Network and
Internet"-"Network
and
Sharing
Center"-"Change
Adapter
Options"-"Ethernet"-" Properties"-"Internet Protocol Version 4
(TCP/IPv4)" - "Use the following IP address"-set the IP address to
192.168.1.xxx.
3. After the power is on for 30 minutes, the temperature measurement,
monitoring and analysis can be carried out through the web terminal
of the computer. For web instructions, please refer to
AT20 Online
Dual-spectrum Thermal Camera Web Client Operation Manual
.
