Make phone call
Redial to last called number
User can dial to the last dialled number by pressing the
POWER/CALL
-button twice
during 2 seconds. Then device beeps shortly and the blue LED lights continuously to
indicate an active phone call. If second pressing is not occurred within 2 seconds, the
device beeps two short beeps and goes back to Standby status.
Make the phone call with voice activation
User can activate the voice dial by pressing the
POWER/CALL
-button continuously for 2
seconds. Then device beeps shortly and user can speak the voice tag (previously recorded
to mobile phone) within 2 seconds. After 2 seconds, device beeps shortly again and phone
dials selected number. The blue LED starts light continuously to indicate an active phone
call. If call command is not entered within 2 seconds or phone does not recognize the
command, device beeps two short beeps and gets back to Standby –status.
End call
Press the
POWER/CALL
-button shortly once to terminate an active phone call. Snake
beeps once and the blue LED stops continuous lighting and starts blinking every 3 seconds
to indicate the Standby -status.
Reject incoming call
Press the
MUTE
-button shortly once to reject an incoming call.
Volume adjustment
Volume can be set by sliding
VOLUME SLIDER
towards left and right.
Switch Between Handsfree and Phone mode
You can transfer calls between the Snake II and mobile phone.
1.
To transfer an active call from Snake II to the mobile phone, press and hold the
POWER/CALL
-button for 3 seconds.
2.
To transfer an active call from your mobile phone to Snake, press shortly the
POWER/CALL
-button.
Note:
This function is phone dependent. You may also transfer calls through the main
menu of your mobile phone. (Please refer to the User Guide of your mobile phone.)
.