Battery charging
When the battery is low, the red light flashes every 3 sec. Battery is recharged by
plugging the charger to charge connector of Snake II. Under normal conditions battery is
fully charged within 6 hours. When battery is full, Snake II stops charging automatically.
During charging the red LED appears continuously. When battery is full, the LED light
disappears.
Power on/off
The Snake is switched ON by pressing the
POWER/CALL
–button for 3 seconds. When
power is switched on, blue light flashes for 5 times and beeps once.
The Snake II is switched OFF by pressing the
POWER/CALL
–button for 3 seconds.
When the power is switched off, red light flashes for 5 times and beeps once.
Pairing with the mobile phone
Pairing with phone is made by pressing
POWER/CALL
-button and
MUTE
-button at the
same time by 5 seconds when the device is in OFF state. The red and blue LED flash in
turn to signal device is searching. When the mobile phone has found the handsfree, phone
shows the name of obtained device “
Iqua Snake 2
”. Pairing the Snake II with phone,
user must select “
yes
” and enter passcode
0000
.
To mark as pairing is successfully completed during 2 minutes, Snake II beeps long once
and starts blinking blue LED every 3 seconds to indicate Bluetooth connection active and
Standby -status.
During pairing, the LED flashing continues for approximately 10 minutes or until the Snake
II is connected to a compatible phone. If the Snake II can not be connected to the phone
during this time, it beeps shortly three times with red LED blinks then the device is
switched off automatically.
Incoming call
Snake II plays ringing tone of mobile phone from its speakers.
Answer call
Pressing
POWER/CALL
-button, user can answer the incoming call. The blue LED starts
light continuously to indicate an active phone call.