© 2018 Copyright Philip Morris Products S.A.
BATTERY REMOVAL INSTRUCTIONS
(FOR DISPOSAL AND RECYCLING)
Batteries must not be removed by the consumer. At end of product life, only an authorized
recycler may safely remove batteries by using the following steps.
IQOS 3 Multi (A1405):
Step 1: Check the voltage: The device should be fully discharged before disassembling it.
Step 2: Rear housing removal (the use of a jig is recommended): Remove the housing
hooks, which are located on the lower side of the device (on the side, close to the
USB socket). The rear housing can now be removed.
Step 3: Sub-assembly removal: Enlarge both sides of the extruded chassis, then remove
the core sub-assembly.
Step 4: Battery removal: Gently pull the battery away from the adhesive backing.
Remove the screws which secure the PCB, then carefully remove the battery and
PCB from the casing. Disconnect the battery cable by using the relevant tool
(AVX 06-9296-7001-01-000).
Step 5: Disposal: Recycle the battery, assembly and PCB according to local regulations.
Hereby, Philip Morris Products S.A. declares that IQOS 3 Multi is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. The official
Declaration of Conformity may be found at: www.pmi.com/declarationofconformity
IQOS 3 Multi Model A1405 operates within the 2.402 – 2.480GHz frequency band with a
maximum RF output power below 10.0 dBm.
Designed and manufactured under the authority of Philip Morris Products S.A., Quai
Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
and any use of such marks by Philip Morris Products S.A. and its affiliates is under license. Other
trademarks and trade names are those of their respective owners.
Содержание 3 MULTI
Страница 1: ...IQOS 3 MULTI User Guide...
