10
c. If Audio and I/O connections are being used, attach them to the appropriate
terminals on the Audio / Triggers terminal block on the camera as shown in
Figure 9.4.
d. Carefully feed the connected wires one at a time back through the pass
through hole.
e. Snap the camera assembly into the mounting ring by sliding one of the
removal tabs under the lip of the mounting ring and firmly pivoting the other
two mounting tabs into the mounting plate. The camera mounting tabs
should snap into place.
10 Camera Positioning, Field-of-View Set-up and Focus
NOTE: Camera positioning, field-of–view and focus set-up can be assisted by connecting an analog test
monitor to the installation / set-up RCA port on the side of the camera.
a. Determine camera pan direction by gripping the camera assembly near the
mounting plate. Carefully pivot the camera to the correct pan position.
b. Open the camera shroud by flipping it down and away from the front of the
camera. The front of the camera is indicated by the lens location.
Figure 9.4
