IQ Vertiq 2306, Инструкция по эксплуатации

Страница: 15 / 17

Vertiq 2306
– APC5x4R - reversible 3D drone using APC5x4R props, velocity mode
– Dal5045 - standard 2D Dal5045 props, velocity mode
– pwm mode- use any prop as you would with a standard motor/ESC, PWM (open-loop) mode.
– 2s empty - voltage mode, motor will run as if it’s running an empty 2s battery
– 2s full - voltage mode, motor will run as if it’s running a full 2s battery
– 3s empty - voltage mode, motor will run as if it’s running an empty 3s battery
– 3s full - voltage mode, motor will run as if it’s running a full 3s battery
– 4s empty - voltage mode, motor will run as if it’s running an empty 4s battery
– 4s full - voltage mode, motor will run as if it’s running a full 4s battery
– 5s empty - voltage mode, motor will run as if it’s running an empty 5s battery
– 5s full - voltage mode, motor will run as if it’s running a full 5s battery
– 6s empty - voltage mode, motor will run as if it’s running an empty 6s battery
– 6s full - voltage mode, motor will run as if it’s running a full 6s battery
Tip: The defaults for specific props allow you to run the motor in velocity (closed-loop) mode for
maximum performance. If you’re unable to do this, we suggest using PWM mode as you would
with a standard motor/ESC or one of the voltage modes
ˆ
Settings Description: Position Module
– position factory default - factory default, unconfigured
ˆ
Make your own pre-settings (for advanced users)
– Locate and open the IQ Control Center’s “resources” folder
– Open the “defaults” folder
– Here you will see all of the .json files that correspond to the GUI’s pre-made settings list
– Create your own file by copying one of the factory default .json files and renaming it
– In that new file, you can change the parameter values. Save this file once you’re done editing.
– Quit out of and reopen the IQ Control Center
– Your new setting should now appear in the list of pre-settings in the General tab
12 Flashing New Firmware
Download Firmware
ˆ
Go to:
www.iq-control.com/products
ˆ
Navigate to your product
ˆ
Select and download your desired firmware (.bin file)
12 FLASHING NEW FIRMWARE
15/17 V1.1
©
2021 IQinetics Technologies Inc.