IQ Power Tools iQ1014S, Руководство оператора

Страница: 12 / 19

iQ1014S
Operator’s Manual
888-274-7744
www.iqpowertools.com
BLADES
6.1
REMOVAL AND INSTALLATION OF BLADE:
1. Push in blade lock button (L) and rotate wheel (J) by
hand until blade lock button engages slot in inside flange
(S) to lock blade. Loosen the bolt (T) counter-clockwise
in the center of the blade with the 8mm hex wrench (G).
Bolt has right-handed thread.
2. Remove the bolt (T), washer (U), outside flange (V).
3. Make sure flange surfaces are clean and flat. Install
new blade by reversing the above steps.
4. Do not over-tighten bolt.
CUTTING CAPACITY:
The iQ1014S® provides a cutting capacity of pieces that
are 4.5” Height Maximum –12” Long Maximum.
CUTTING:
• A cut is performed by cutting completely through an
object in one pass.
• Cut setup: Engage switch to start blade motor, position
work piece below the blade.
• Using the Handle, lower the Cutting Head to
begin cutting.
• Using the Handle, continue to lower the Cutting
Head until the cut is complete.
• When the cut is complete, turn off switch. Allow the
blade to stop before removing work. Using the Handle
to raise the Cutting Head.
CUTTING WITH THE CUTTING HEAD LOCKED DOWN:
• Hold the cutting head down while engaging the lock pin
into the lockdown hole.
• Hold work in position, engage switch to start motor.
• Push work material into the blade until the cut is
complete. Allow the blade to stop moving before
removing any material from cutting table.
DO NOT FORCE TOOL! It will do the job better and
safer at the rate for which it was designed.
OPERATION TIPS FOR MORE ACCURATE CUTS:
• Allow the blade to do the cutting. Excessive force will
cause the wheel to glaze reducing cutting efficiency
and/or to deflect, causing inaccurate cuts.
• Make sure material is laying flat across the base.
Correct Way Wrong Way
Never cut directly on top of material as shown above.
This can result in serious injury.