SETUP, ADJUSTMENT & OPERATION
CUTTING CAPACITY:
The IQ 360 provides a cutting capacity of pieces that are 3.5” Tall Maximum –12” Long Maximum.
CUTTING:
A Chop Cut is performed by cutting completely through an object in one pass.
Chop cut setup: Depress Trigger to start (lock if desired). Position work below the Blade.
Using the Handle, lower the Cutting Head to begin cutting.
Using the Handle, continue to lower the cutting head until the cut is complete.
When the cut is complete, release the Trigger Switch. Allow the Blade to stop before removing work. Using the Handle
to raise the Cutting Head.
CUTTING WITH THE CUTTING HEAD LOCKED DOWN:
Set adjustable depth control by depressing button on side of control, Up or down for desired position.
Hold work in position, depress trigger to start motor.
Push work material into the blade until the cut is complete. Allow the blade to stop moving before removing any material
from cutting table.
OPERATION TIPS for MORE ACCURATE CUTS:
Allow the blade to the cutting. Excessive force will cause the wheel to glaze reducing cutting efficiency and/or to deflect
causing inaccurate cuts.
Make sure material is laying flat across the base.
Correct
Way
Wrong
Way
Never cut directly on top of material as shown above. This can result in serious injury and dust exposure
CAUTION
DO NOT FORCE TOOL!
It will do the job better and
safer at the rate for which it was designed.
11
Содержание IQ 360
