IQ Gate Systems IntelliSlide IQ-5000, Инструкция по установке и эксплуатации, Страница: 4 / 28

4
IQ Gate Systems: IQ-5000 Installation
IQ-5000 Capacities:
Slide gates that are up to 1500 lbs and 35 feet in length
Important Safety Instructions
WARNING –
TO REDUCE THE RISK OF INJURY OR DEATH - READ AND FOLLOW ALL INSTRUCTIONS.
Never let children operate or play with gate controls. Keep the remote control away from children.
Always keep people and objects away from the gate. NO ONE SHOULD CROSS THE PATH OF
THE MOVING GATE.
Test the gate operator monthly. The gate MUST reverse on contact with a rigid object or stop when
an object activates the non-contact sensors. After adjusting the force or the limit of travel, retest the
gate operator. Failure to adjust and retest the gate operator properly can increase the risk of injury or
death.
Use the emergency release only when the gate is not moving. Make sure that all power to the gate
operator is off.
KEEP GATES PROPERLY MAINTAINED. Read the owner’s manual. Have a qualified service person
make repairs to gate hardware.
The entrance is for vehicles only. Pedestrians must use separate entrance.
SAVE THESE INSTRUCTIONS.
Warning:
To reduce the risk of injury or death, please read the following:
1. Read, follow and understand all instructions
2. The automated gate is not for pedestrian use
3. Do not activate your gate operator unless it is in sight and you can determine that it will travel without
interfering with any objects or persons. Always keep people and objects away from the gate and its
area of travel
4. Keep all access devices such as key switches, push buttons, and telephone entry systems away from
the gate. The recommended distance is a minimum of 10 feet.
5. Make sure that all warning signs have been attached and that the operator has been installed
correctly
6. If edges and photoelectric sensors have been installed, they should be tested for proper operation.
7. Keep gates properly maintained. Grease and lubricate all hinges and brackets to prevent binding and
unnecessary friction.
8. Have the operator tested and serviced by a qualified and experienced technician. The gate should
respond and reverse to all obstructions both inherently and externally
9. Disconnect the operator only when it is not in motion
10.
DO NOT turn on the automatic close timer unless the gate is equipped with at least one non-contact
external obstruction sensor, e.g., a photo electric beam, a vehicle loop, etc.
!
Warning:
Do not install this gate operator if you
don’t have experience or proper training with gate operators