IPSO PS40, Руководство пользователя, Страница: 41 / 99

41
Operating mode 6
Time stop ( not on machines with coins )
By pressing the “STOP” button longer than 3 seconds, the program comes in “ time stop ” (if “
EMEr
” was selected
in the “pre-program”).
With this you can for instance extend a program for very dirty linen. The time is stopped and the step is continuously
executed. The programmed water level and temperature are maintained. During the “time stop”, “
((tistop
”
is indicated.
Now you can possibly program the stop time. Therefor press “ENTER”. Now “
(( ti ((
” is indicated. Program
by means of “X,X,X” the stop time (from 1 to 999) minutes and press “E”.
The display shows by turns “
((tisto
” and the counting stop time left. Once the stop time is passed, the program
time continues automatically.
If no stop time is programmed, the stop will be executed continuously until “START” is pressed.
A "time stop" during the spin is automatically broken off after 20 minutes.
Break off or stop a program
When the “STOP” button is shortly pressed, the display text blinks and the water is evacuated after 5 seconds (only
if emergency stop (“
EMEr
”) was selected in the “pre-program”). The buzzer starts after 30 seconds,
“
oPEn door
” appears and the door has to be opened. Afterwards
“CloSe”
appears.
When the door is locked again, you can :
- continue the program by pressing “START”
- stop the program permanently by pressing “STOP”.
The stop function operates during spin1 with 60 seconds delay and during spin2 with 120 seconds delay.
Add water (not for coin machines)
By pressing first button “ 1 ” and then one of the buttons from “1” till “9” during a program, the corresponding inlet
valve is opened.
By pressing first button “
2 ” and then one of the buttons from “1” till “3” during a program, the corresponding inlet
valve is opened.
While pressing, the chosen inlet valve and level are shown ,“
X
i( l((
L ”. This indication lasts for 3 seconds
after releasing.
These functions do not operate during the first 3 minutes of the program.
Water exhausts (not for coin machines)
By pressing first the “ 0 ” button and then one of the buttons from “1” till “4” during a program, the corresponding
exhaust valve is opened.
While pressing, the chosen exhaust valve and level are shown “
d( l((
”. This indication lasts for 3 seconds after
releasing.
This function does not operate during the first 3 minutes of the program.
Warm up the bath
By keeping the button “ 4 ” pressed during a program, the heating is activated (max. 95 °C). While pressing, the
temperature of the bath “
$C ((
” (or “of
$F ((
”) is shown.
This function does not operate during the first 3 minutes of the program.