IPSO PS40, Руководство пользователя, Страница: 39 / 99

39
´
´
´
´
Operating mode 6
Programmed start ( not on machines with coin )
Press " START " and keep it pressed for more than 5 seconds after a program has been selected.
"
dELAY .XX " appears on the display.
By entering a digit between 0 and 99, the start can be postponed per hour.
Press " START " again to start the count down ( the decimal point blinks ).
In the last hour, the minutes are blinking on the display.
Remark:
To stop the countdown: press " STOP ".
Changing the program
The first 3 minutes after starting, you still have the possibility to change the program. Enter another program
number.
"
P.((.StArt
" will appear on the display. "
P.((
" represents a new program number.
Press " START " to confirm.
Remark:
On machines with coin ( if a more expensive program has been selected ), the amount due "
(((.((
" appears.
The first program keeps running till the coins are inserted. If this doesn’t happen, the program will continue
3 minutes after the first start.
Changing the level, the washing time and the temperature settings once.
Select the program number.
Before starting the program , press " NO " and " ENTER " at the same time.
Per program part, firstly the level "
L ((
", the washing time "
t ((
" and then the temperature "
$C ((
" appear on the display. Change these data if necessary and press " ENTER " to proceed with the washing time
and temperature settings of the next program part.
Start the program with " START " after the setting have been modified.
Remark:
The value of "
LECo
" en "
HECo
" is being changed downward with the same value till a minimum of
" 00 " is reached.
The program will only be executed once with the settings modified in this manner. This function cannot be
realized on machines with coins.
Controlling the temperature of the bath and the number of revolutions
By pressing the " NO ", you can read the temperature of the bath and the number of revs for 5 seconds.
These functions are only operative if temperature reading ("
t
") has been selected in " pre -program " .
Press once :
The temperature of the bath is given, followed by a horizontal line. (
t=(($C,
) .
Press twice:
The highest temperature in the program is given, followed by three horizontal lines (
t=(($C%
).
Press three times:
The highest temperature in the program is given, followed by three horizontal lines (
t=(($C+
).
Remark:
When the temperature measured is less than 25 °C, the message "
Cold
" is displayed.
Press four times:
On machines with frequency controlled motor ( " FC " in " pre-program ", the number of revolutions
is given ).