IPSO PC30, Руководство по перепрограммированию

Страница: 40 / 74

41
Operating mode 6
In case of a programmed start (not with coin-op version)
After the program has been selected, press the " START " button for at least 5 seconds.
" dELAY .XX " will appear on the display.
The start can now be delayed per hour by entering a number between 0 and 99. Then press the " START " button
once more so that the countdown can begin (decimal point flashes). During the last hour of the countdown the
minutes are shown (flashing).
Remark:
If you want to cancel the countdown, press " STOP ".
Changing to another program
It is possible to change to another program during the first minutes after a start. Herefore you put in another
program number.
On the display " P.XX.StArt " will appear. " P.XX " stands for the new program. Then confirm by pressing
" START ".
Remark:
In case of coin-op machine, if the new program is more expensive, the additional amount required for this
program is shown in " XXX.XX ". The originally selected program will continue until the additional amount is
inserted. If this is not inserted, the original program will continue 3 minutes after the first start.
One-time modification of the level, wash time and temperature input.
Select a program number.
Before starting this program press " NO " first and then press " E " while keeping " NO " depressed. For each
program segment " L XX " followed by " t XX " and then " °C XX " will appear on the display. Adjust the data
if necessary and press " E " to continue to the wash time and temperature input of the next segment.
When all input is adapted according to your requirements, press " START " to initiate the program.
Remark:
The values of " LECo XX " and " HECo XX " are modified by the same values up to a minimum of " 00 ".
The program will be executed only once with the modifications that have been applied in this manner.
Control of the temperature of the bath
By pressing the button " T " it is possible to read the temperature and the rotation speed of the drum on the
display.These functions are only operational if the temperature reading function ("t") was selected in the "pre
program mode".
Press " T " once:
The temperature of the bath is displayed (" t=XX°C " followed by one horizontal bar).
Press " T " twice:
The programmed temperature of this segment is displayed ( " t=XX°C "followed by two horizontal bars).
Press " T " three times:
The highest temperature for this program is displayed ( " t=XX°C " followed by three horizontal bars).
When the displayed temperature is less than 25°C , " Cold " will appear.
å
å
å
å
Press " T " three times:
The rotation speed will be displayed if it is a frequency controlled machine ("FC"in th pre-progam
mode).