FXO2
User Guide ver. 1.1
Autotranslation, no pics
2 SIP, 2xRJ45, 4xRJ11
Pre-version userguide
page 4 of 13
© IPshop ApS 2009
I:\FAQ\FXO2\userguide\FXO2_UG_EN.doc Ver. 1.1
Multiple Language Support
1.5 List of the Package
a) One FXO2 main unit
b) One DC12V/500mA power adaptor
c) One Ethernet cable (3M)
1.6 View of the Appearance
1
）
FXO 1
It is connected to the PSTN with RJ11 connector.
2
）
FXO 2
It is connected to the PSTN with RJ11 connector.
3
）
Line1
Internal connected to the Line1; User can connect a spare phone to this socket.
4
）
Line 2
Internal connected to the Line1; User can connect a spare phone to this socket.
5
）
LAN
Connect to the switch, DSL modem or other network access equipment.
6
）
PC
Connect a computer or other terminal.
7
）
POWER DC12V/500mA
It is the power source, connect to the power adapter.
8
）
Reset
Press it with a nail to reboot the terminal or long press to reset terminal configuration.
2 Installation
2.1 Installation Steps
The FXO2 IP ADAPTOR has two PSTN ports
（
FXO1 and FXO2
），
one NETWORK
port
and one PC port. The VoIP channels can login by same SIP (or H.323) account or two
different SIP (or H.323) accounts.
Please follow the steps below to install an FXO2 IP ADAPTOR:
a) Connect the PSTN lines to the FXO1 and FXO2.
b) Insert the Ethernet cable into the LAN port of FXO2 IP ADAPTOR and connect the
other peer to the internet access equipment.
c) Connect a PC to the PC port of FXO2 IP ADAPTOR.
d) Insert the power adapter into the FXO2 IP ADAPTOR and power up.
2.2 Connection Diagram
The interconnection diagram is as below:
2.3 LED Light Pattern Indication
The following table shows the LED light pattern indication.
LED DESCRIPTION
RUN 1. When the device is booting up, the LED
will flash 100ms ON and 100ms OFF.
2. When the account is logon, the LED will
flash 1s ON and 1s OFF.
3. If the ATA does not boot up, the LED
will not flash.
4. Normally boot up and login time needs
