IPOXUSA IP-M45A1, Руководство пользователя, Страница: 20 / 80

- 14 -
Installation
- 14 -
Jumpers
JBAT1: Clear CMOS Setup (9)
If the board refuses to boot due to inappropriate CMOS settings here is how
to proceed to clear (reset) the CMOS to its default values.
Connector type: 2.54 mm pitch 1x3 pin header
Pin Mode
1-2 Keep CMOS (Default)
2 3 1
2-3 Clear CMOS
2 3 1
You may need to clear the CMOS if your system cannot boot up because you
forgot your password, the CPU clock setup is incorrect, or the CMOS settings
need to be reset to default values after the system BIOS has been updated.
Refer to the following solutions to reset your CMOS setting:
Solution A:
1. Power off the system and disconnect the power cable.
3ODFHDVKXQWWRVKRUWSLQDQGSLQRI-%$7IRU¿YHVHFRQGV
3. Place the shunt back to pin 2 and pin 3 of JBAT1.
4. Power on the system.
Solution B:
If the CPU Clock setup is incorrect, you may not be able to boot up. In this
case, follow these instructions:
1. Turn the system off, then on again. The CPU will automatically boot up
using standard parameters.
2. As the system boots, enter BIOS and set up the CPU clock.
Note:
If you are unable to enter BIOS setup, turn the system on and off a few
times.