连接接口
Specification
连接接口
Item
Description
Power
Power Supply
Power Adapter
Voltage Range
DC5V
Power Consumption
＜5W
Ethernet Port
Ethernet Port
LAN Port:10/100Mbps
TransmissionDistance
LAN Port: 0～100m
Optical Port
Optical Port
Single Fiber SC Port
Wave Length
Transmitter:1310nm/1550nm
Receiver:1550nm/1310nm
Bandwidth
155Mbps
Ttransmission Distance
Single Mode Fiber:20km; Mutil-mode Fiber:2km
Network Switch
Ethernet Standard
IEEE802.3 10BASE-T, IEEE802.3u 100BASE-TX/FX
Status Indicator
Power Light
1 (Green)
Ethernet Indicator Light
RJ 45 Port 1(Green)
Optical Indicator Light
FED, SD, LINK 3 (Green)
Protection
ESD
1a Contact Discharge 3 level 6KV
1b Air Discharge 3 level 8KV
Per:IEC61000-4-2
Working
Environment
Working Temperature
0 ~55℃
℃
Storage Temperature
-40 ~75℃
℃
Humidity(Non-condensing)
0~95%
Mechanical
Dimension(L*W*H)
83mm×90mm×25mm
Material
Aluminium
Color
Black
Weight
100g
连接接口
Trouble Shooting
Please follow the steps if the equipment has trouble.
Make sure the equipment is installed according to the manufactures installation guide;
Please confirm if the RJ45 cable order is in accordance with EIA/TIA568A or 568B
standards;
The maximum transmission distance depends on the quality of signal source and
transmission cable, Please do not exceed the device's maximum transmission distance;
Replace the equipment that can not work with a proper functioning optical fiber
transceiver to check if the equipment is damaged;
Please contact your vendor if trouble still exists.
Optical Fiber
Transceiver
3
4
Optical Fiber Transceiver
Instruments to be used: wire crimper, network tester, Wire sequence of RJ45 plug should
conform with EIA/TIA568A or 568B standards.
1) Please remove 2cm long the insulating layer and bare the 4 pairs UTP cable;
2) Separate the 4 pairs UTP cable and straighten them;
3) Line up the 8 pieces of cables per EIA/TIA 568A or 568B;
4) Cut off the cables to leave 1.5cm bare wire;
5) Plug 8 cables into RJ45 plug, make sure each cable is in each pin;
6) Use the wire crimper to crimp it;
7) Repeat above 5 steps to make the another end;
8) Use network tester to test the cable whether it works.
RJ45 Making Method
Pin Color
White/Green
Green
Blue
White/Orange
White/Blue
White/
Brown
Orange
Brown
1
2
3
4
5
6
7
8
Pin
Color
1
2
3
4
5
6
7
8
White/Green
Green
Blue
White/
Orange
White/Blue
White/Brown
Orange
Brown
EIA/TIA 568A
EIA/TIA 568B
Notice
When choose RJ45 make sure if one end is EIA/TIA568A,the other end should also be EIA/TIA568A.
When choose RJ45 make sure if one end is EIA/TIA568B,the other end should also be EIA/TIA568B.
Specification change will not be noticed
