Please follow below the installation steps
Check the following items before installation(in pair), if any missing, please contact the dealer .
Optical Fiber Transmitter 1 pcs
Optical Fiber Receiver 1 pcs
Power Adaptor 2 pcs
Hangers 4 pcs
User Manual
1 pcs
1)P
power on will damage the device;
2) Please check if the network cable and other transmission cables are occupied by other device;
3) Use a network cable to connect with optical fiber transceiver's LAN port and NVR or computer,
etc.;
4) Use one single mode single optical fiber to connect with two optical ports of the optical fiber
transceiver. One end of the fiber should connect with optical transceiver's TX port, the other end
should connect with the RX port;
5) Check if the installation is correct and device is good, make sure all the connection is reliable
and power for the system;
6) Make sure the network is normal.
lease turn off the signal power and the device's power before installation, installation with
Optical Fiber Transceiver is a fast Ethernet optical fiber transmission equipment, which can
achieve different transmission mediums transformation over network cable and fiber and
support 10/100Mbps network bandwidth. The product can be used in pairs, including
transmitter and receiver. It is widely used in security surveillance system and Ethernet fiber-
to-the-home occasion, etc.
Feature
Provide 100Mbps 1 optical fiber port and1 Ethernet port, which can achieve the data
transformation between optical fiber and Ethernet;
Support 1X9 optical module and SC port, use single mode single fiber that the transmission
distance can up to 20km;
Compatible with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX/FX Ethernet standards;
Support 10/100Mbps full/half Duplex automatic adaptation, support automatic MDI/MDIX;
Power adaptor uses aerial socket,
improves the performance and stability;
Dynamic LED indicator light achieve real-time display of the equipment current working
condition, provides simple working condition indicator and troubleshooting;
Compact aluminum shell design, easy for desktop and wall-mounted installation.
effectively
Optical Fiber Transceiver
User Manual
Notice
1
2
Please note that 2 optical fibers should cross connect with two optical fiber ports of the
transceiver.
VerB 1.1
Board
Diagram
Optical Fiber Transceiver
1) Power is power indicator; FED, SD, LINK is optical fiber port indicator, they mean:
Link: indicate optical port connection status, On: connection ok; Off: connection failed;
Flash: connection ok and has data switch.
SD: optical port signal detection, On: optical fiber connection right; Off: without optical
fiber connection.
FED: remote failure mode receive, On: 80ms Off: 20ms Always off: no receive.
2) LED failure indication function, please refer to the below table:
Description:
Right
Board
Ethernet LED
Optical Port
Link
Optical Port
SD
Optical Port
FED
Status
On
On
On
Off
Connection ok
Flash
Flash
On
Off
Connection ok and has data switch
Off
Off
On
Off
Remote Ethernet port can not connect
Off
Off
Off
Off
Fiber RX off line, fiber TX/RX offline
TX/RXdropped
Off
Off
On
Flash
Fiber TX off line
Optical
port
Power and optical
indicator light
POWER
Power input
5VDC
Fiber
SD
FED
Link
Power
SD
FED
Link
Ethernet port
Left
Board
Application
IP C
ame
ra
Optic
al Fib
er T
ransc
eiver
E
ther
net S
witc
h
Netw
ork C
able
Optic
al Fib
er T
ransc
eiver
Fi
be
r
Netw
ork C
able
Installation
steps
