iPort IW-20, Инструкция по эксплуатации

Страница: 15 / 20

15
i Po r t I W- 2 0 / I W- 2 1 / I W- 2 2
I n s t r u c t i o n M a n u a l
12. Insert the iPort utility box into the opening in the wall.
• First insert the top edge into the opening, then rotate the bottom edge into the opening.
Note: The Roto-Lock system can accommodate a maximum wall material thickness of 1
3
/
8
”.
13. Hand-tighten the two Roto-Lock screws on the iPort utility box as shown in Figure 5, page 8. The Roto-Lock clamps will
automatically rotate into position behind the wall and begin clamping the iPort.
• When you notice resistance on the two screws, the iPort has been clamped successfully.
IMPORTANT: NEVER over-tighten the Roto-Lock screws.
14. If there is a wall stud up against one side of the utility box that prevents one Roto-Lock clamp from operating, secure the
box by hand-driving a 1½” #6 drywall screw (not provided) through the angled hole on that side of the chassis and into
the wall stud. See
Figure 5, page 8.
IMPORTANT: Do not over-tighten the drywall screw.
15. Confirm that the switches for the Selectable Features are set in the correct positions (see Selectable Features,
page 4), and attach the iPort face to the utility box as shown in
Figure 6, page 8. Slide the face all the way into
the box until it fits snugly into place.
16. Plug the included DC power supply into the PWR connector on the wall plate and into a wall outlet, as shown in Figure
10, page 13.
Adjusting the iPort for Different iPod Models
The iPort is compatible with most dockable iPods including 4th Generation
and newer iPod models, iPod touch, and iPhones, including iPhone 3G. iPod
features change often. For updated compatibility visit iportmusic.com.
• To adjust the iPort for smaller iPod models, extend the iPort’s center disc
forward by rotating it counter-clockwise until you feel the detent
(see
Figure 13). Spring-loaded clamps at the bottom of the iPort well will
hold smaller models in place.
• When switching back to larger iPod models, retract the iPort’s center
disc backwards by rotating it clockwise until you feel the detent
(see
Figure 13). When these larger models are placed in the iPort well the
spring-loaded clamps will rotate out of the way.
For
Larger
iPod Models For
Smaller
iPod Models
ROTATE
DISC
Figure 13: Adjusting the iPort for
Different iPod Models