IPN W9 Series, Руководство по эксплуатации

Страница: 14 / 22

14
Ÿ
Press and hold the 'TEL' or ‘Registration’ button on the headset base for five seconds to
enter the registration mode. The 'TEL' LED will flash to indicate it is in registration mode.
Ÿ
The headset will now be registered to the base which will take around 30 seconds. When
the registration has completed, the base ‘TEL’ LED will stop flashing.
The additional 2 auxiliary headsets can be registered using the same procedure but instead of
the ‘TEL’ button, use the microphone ‘Up’ button for headset 2 and the microphone ‘Down’
button for headset 3. These can be found on the underside of the headset base.
seconds. The LED’s of the PC/USB and TEL buttons will light. If one of the buttons is pressed
again this function will be turned off.
3.9 Registering headsets to the base
Up to three headsets can be registered permanently to the W9xx base. You can register a new
headset unit to your base using the following procedure.
Ÿ
Press and hold the 'Headset ON/OFF' button on the headset for five seconds for the
headset to enter registration mode.
3.10 Using multiple headsets
If you have more than one headset registered to the W9xx base, the first headset to be turned
on becomes the primary headset and takes control of the base. Another headset can then join
and leave the call by the user pressing their headset buttons, but only the primary headset can
end the call. NOTE: Only one of the two additional headsets can connect at any one time.
This function can be enable or disable as follows:
3.11 Using the IPN W9xx with Microsoft Lync (Models W970/W980/W985/W990/W995)
When your W9xx is connected to a PC using the USB cable, it can interact with Microsoft
Lync/Skype For Business communication software installed on your PC. The headset button can
be used to answer and end a call and if you activate and finish a call using the desktop software
the headset will automatically turn on and turn off.