12
9.5. After the address is written, the controller automatically jumps to the address test function. At
this time, the screen displays:
①.
AC: **** Automtic test
②.
MC: **** Manual test
③.
ALL- ALL All controller all ports
④.
CH MODE
：
Channel (
Interval channel is not adjustable
）
Note: The address port is set by "CONTR NUM /PORT NUM" before address writing (in this case, all ports of all
controllers)
9.6.
Press the
“MODE”
button to enter the
“AC”
automatic test mode, the lamps will start to light up in sequence,
and the number will increase automatically;
The controller displays the following picture:
9.7. Press the
“MODE”
button again to enter the
“MC”
manual test mode;
“SPEED+”
and
“SPEED-”
can adjust
the pixel points (long press “SPEED+” and “SPEED-” can
quickly increase or decrease), and the lamps will light
up one by one;
Display as shown:
9.8. After the test is completed, press
“
SET
”
to exit the channel test and return to the write address
interface.
9.9. Press the
“
MODE
”
button to move the arrow to select
“
Return
”
, then press
“
SET
”
to exit
the address and test, and then restart to return to the playback mode.
10
、
Lamp address test mode
（
Test the load on all ports of the controller
）
10.1. Press the
“
SET
”
button and turn on the controller. Press the
“
MODE
”
button to move
the arrow to select
“
TEST DMX ADDR
”
.
As shown in the figure:
10.2. Press the
“
SET
”
button again to enter the luminaire test mode interface, as shown in the
figure.
①. AC: ****
Automatic test
②. MC: ****
Manual test
③. ALL-ALL
：
All controllers all ports
④. CH MODE
：
Channel
