ü
Connection ( Wireless )
To connect VZ-X wirelessly to your iOS/Android devices (iPad/iPhone/Android
Tablet/Android Phone), Mac or PC, please follow the steps below:
1. Download the free software “IPEVO Visualizer” for VZ-X at
http://support.ipevo.com/vzx.
2. Turn VZ-X on using the Power Switch.
3. Press the Battery Check Button and check VZ-X’s remaining battery level. Make
sure there’s sufficient battery power to last you through your session. If VZ-X is
low on battery, please recharge it by following the steps stated in “Charging VZ-X”.
4. Check the LED Indicator. Make sure the Green and Amber lights are on. If the
Amber light is not on, please switch VZ-X to its Wi-Fi mode using the Mode
Switch located on the back of its body.
5. Turn on the Wi-Fi of your device. Browse the available connections and connect
to VZ-X’s SSID. The unique SSID can be found on the label located on the bottom
of VZ-X.
6. Launch IPEVO Visualizer. A live image from VZ-X should appear on your device.
Note:
(1) VZ-X only supports 2.4GHz Wi-Fi network and not 5GHz.
ü
Reset
You can reset VZ-X’s Wi-Fi network settings to the factory default. To do so, please:
1. Make sure VZ-X is in the Wi-Fi mode.
2. Turn VZ-X off if it hasn’t been done so.
3. Press and hold on both Increase Exposure and Decrease Exposure buttons.
4. Turn VZ-X on while holding down the buttons.
5. The LED Indicator will briefly show Green, Amber and White. You can then
release the buttons. VZ-X is now reset.
