11
10
Installing It (cont’d)
6. Calibration
IS-01 must be calibrated before use to ensure accurate operation. This process only takes a
couple of steps.
For PC, the calibration application will appear the first time the Sensor Cam is connected to the
computer. For Mac, if you are using the IS-01 for the first time, you’ll need to double-click on the
“IS-01 Driver” to start it up. After that, the IS-01 icon will appear on the top right of your status
bar and you can click on it and run the calibration application from the drop-down menu.
When calibrating, please use the Interactive Pen and follow the instructions on screen (and
reprinted below) to complete the calibration.
Any time after the first time that you wish to calibrate, execute the following file:
PC:
Start Menu -> Program files -> IPEVO -> IS-01 -> Calibration
Mac:
Application folder -> IPEVO IS-01 -> Calibration
Note: The Interactive Pen must have batteries and be switched on for calibration and operation.
Calibration Steps
Step 1: Sensor Cam Coverage Detection
Tap each corner white square (in any order) with the tip of the Interactive Pen. Make sure the
resulting dots appear inside the center white box. If not, please move the Sensor Cam until all
points are contained within the white box. Then, press Space to continue.
IS-01 requires IPEVO IS-01 Driver to function. If you have not previously installed the Driver,
please refer to Page 5 for the downloading and installation instructions.
Step 2: Accuracy Check
With the Pen, tap the center of each red crosshair that appears. Four crosshairs will appear in
total. You MUST tap all four in turn. Failing to do so may impair Pen accuracy.
Step 3: Calibration Completed
After the process you will be returned to your desktop and your IS-01 will be ready for use.
Sensor Cam Diagnosis
If you find the pen trace dithering or inaccurate after the initial calibration, your Sensor Cam
may need further adjustment. Please run the Sensor Cam Diagnosis and reposition the Sensor
Cam according to the suggestions given.
This diagnostic tool is located in:
PC:
Start Menu -> Program Files -> IPEVO -> IS-01 -> Sensor Cam Diagnosis
Mac:
Application folder -> IPEVO IS-01 -> Sensor Cam Diagnosis
