iPECS LIK-MFIM50A, Руководство по описанию оборудования и инструкция по установке

Страница: 47 / 59

- LIK50
Description & Installation
Issue
1.2.1
41
4.4.4 General Installation
The following paragraphs provide general and common installation and wiring practices and
procedures for both LIK-MFIM50A and LIK-MFIM50B. Procedures such as LAN wiring are
common for all LAN ports and are discussed here. Prior to installation of any Module, it is
recommended the installer be thoroughly familiar with the information in this section.
Modules must be installed in a Wall Mount Holder, Desk Holder or 1URMB for
proper ventilation. Do not stack Modules or limit airflow as this may cause over-
heating, leading to pre-mature failure and/or faulty operation of the equipment.
4.4.4.1 Miscellaneous Connections
Miscellaneous connections are via RJ-45 type jacks in the rear of LIK-MFIM50A MFIM50B
are wired as in Figure 4.4.4.1-1.
Figure 4.4.4.1-1 Miscellaneous connections
4.4.4.2 Telephony (FXS/FXO) Connections
FXO and FXS (PSTN and SLT telephone) connections via RJ-11 or RJ-45 type jacks in the rear of
LIK-MFIM50A/B (RJ-45) are wired as in Figure 4.4.4.2-1. All telephone wiring should use standard
two (2)-pair twisted 24 or 26 AWG wiring.
TIP
RING
To PSTN Tip/Ring terminations
or SLT Tip/Ring terminations
1 2 3 4 5 6 7 8
RJ-45 Connector
Figure 4.4.4.2-1 Pin Assignments of Telephony (RJ11 or RJ-45) Connector
To reduce the risk of fire, use only 26 AWG or larger UL List or CSA Certified
Telecommunication Line Cord.