IPC CT46, Руководство оператора, Страница: 28 / 34

EN
At the end of work: At the end of work:
► ► release the brush lever (fig. D, ref. 1); release the brush lever (fig. D, ref. 1);
► ► turn the machine off by pressing the button (fig. C, ref. 3) for at least 4 seconds. turn the machine off by pressing the button (fig. C, ref. 3) for at least 4 seconds.
► select the direction of travel (fig. D, ref. 6 - battery-powered model with traction drive only);
► press the main switch (fig. C, ref. 8) cable model only
► ► use the lever provided (fig. D, ref. 2) to raise the squeegee off the floor and prevent continuous pressure use the lever provided (fig. D, ref. 2) to raise the squeegee off the floor and prevent continuous pressure
from deforming the drying blades, standard version with brushes and pad drive boards; from deforming the drying blades, standard version with brushes and pad drive boards;
► raise the head and position the transport wheel (see section Moving the machine when not in opera
-
tion)
► depending on the model, unplug from the mains socket or disconnect the batteries,
► empty and clean the dirty water tank.
Some useful tips to get the most from your scrubber dryer
In cases where floors are soiled with particularly stubborn dirt, scrubbing and drying operations can be performed
in two separate stages.
Prewashing with brushes or pads
► press the main switch (fig. C, ref. 3) (LED on);
► set the percentage of detergent to be released by the Chem Dose (OPTIONAL) (fig. P, ref. 2).
► press the brush button (fig. C, ref. 4) (LED on),
► press the suction button (fig. C, ref. 5) (LED off) to turn suction off;
► operate the brush lever (fig. D, ref. 1) to enable brush rotation;
► make sure the suction motor is off and the squeegee is raised;
► begin washing.
► during cleaning operations, check the quality of the wash: if necessary, adjust the flow of detergent to
the brush using the detergent solution tap (fig. F, ref. 2) and adjust the percentage of detergent released
from Chem Dose (OPTIONAL) by turning the knob (fig. P, ref. 2).
►
Persist when washing particularly dirty points to give the detergent time to perform its chemical action
detaching and suspending the dirt and the brushes time to exert an effective mechanical action.
Drying
Lower the squeegee and with the suction motor on, pass over the same area washed previously.
The result is The result is
equivalent to in-depth washing and subsequent ordinary maintenance will take less time. equivalent to in-depth washing and subsequent ordinary maintenance will take less time.
Draining the dirty water Draining the dirty water
DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply (cable model)
.
The dirty water tank drain hose is at the back of the machine on the right.
To empty the tank:
►
position the machine near a drain;
► detach the drain hose (fig. A, ref. 7) from its seat by holding it near the fixing spring and pulling horizon
-
tally;
► keeping the end of the hose as high as possible, remove the cap;
► lower the end of the hose gradually, controlling the intensity of the flow of water by adjusting the height
from the ground;
►
check the amount of dirt left in the dirty water tank and if necessary wash it out;
► close the drain hose with the cap. Check that it is tightly closed and replace the hose in its housing.
► You are then ready to wash and dry again.
28