IPC CT15R, Руководство оператора

Страница: 30 / 41

GB
DANGER
Use CE-marked battery chargers that comply with the relevant product standards (EN60335-2-29),
featuring double or reinforced insulation between input and output, and a SELV output circuit.
The CT46 B50 must only be powered by a low safety voltage.
Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the connector supplied with
the machine (see paragraph “Unpacking” in this manual).
To install the connector, proceed as follows:
► remove about 13 mm of protective sheath from the red and black wires of the battery charger;
► insert the wires into the connector contacts and squeeze them forcefully with suitable pliers;
► respect the polarity (red wire + black wire –) when inserting the wires into the connector.
Lifting and transporting the machine
IMPORTANT
All phases must be performed in an adequately lit room and adopting
the safety measures most appropriate to the situation.
The operator must always use personal protection devices.
To load the machine onto a means of transport, proceed as follows:
► empty the dirty water and detergent tanks;
► place the machine in the packaging, then rest the packaging on a pallet and fix it with plastic straps;
► lift the pallet (with the machine) using a fork lift truck and load it onto the means of transport;
► anchor the machine to the means of transport with cables connected to the pallet and machine itself.
PRACTICAL GUIDE FOR THE OPERATOR
Controls - Description
With reference to fig. C, the machine has the following controls and indicator lights:
► Power on light (fig. C, ref. 7 - cable model only): green, indicates that the machine’s power cable is
connected to the mains.
► Battery charge light (fig. C, ref. 2 - battery models only): 3 LEDs (red, yellow and green) which indicate
the level of battery charge. There may be:
► red and green LEDs on, yellow LED flashing: battery voltage > 30.0 V;
► red, yellow, green LEDs on: battery voltage from 30.0-23.3 V;
► red, yellow LEDs on: battery voltage from 23.5-22.5 V;
► red LED on: battery voltage from 22.5-21.9 V;
► red LED flashing: battery voltage from 21.9-21.4 V, batteries completely discharged; after a few
seconds the brush and suction motor shut down;
► red, yellow, green LEDs flashing, ECS model and Roller model, excessive brush motor current
draw, excessive head pressure on working surface.
► Instrument panel main switch - (Fig. C, ref. 3): connects (LED on) and disconnects (LED off) power to
all the machine’s functions (to turn the machine off, hold the button down for at least 4 seconds). In the
BT version, the LED flashes during operation.
► Main switch - (Fig. C, ref. 8 - cable model only): connects and disconnects power to all the machine’s
functions.
► Brush button with light (fig. C, ref. 4): enables (LED on) and disables (LED off) the “brush” function. The
brush does not start rotating until the brush lever is operated. ECO function (battery models only), used
to reduce brush motor power by 20%, to activate this function, operate the “Brush lever” then press the
button for a few seconds, until the LED starts flashing.
i INFORMATION
When the brush button is pressed, suction and detergent delivery are also enabled automatically.
30