IPC CT105 BT70 Traction, Руководство оператора

Страница: 21 / 37

GB
Moving the machine
To displace the machine do as follows:
► lift the squeegee;
► raise the head by pressing the brush up-down button (fig. 8, ref. 5) on the arrow up;
► disengage the parking brake via the pedal (fig. 8, ref. 12);
► activate the main switch (Fig. 8, ref. 13);
► in front of the handgrip is a lever (fig. 10, ): by pulling the lever towards the operator (fig. 10,
ref. 2) or pressing it towards the machine’s front axle (fig. 10, ref. 1), according to whether
you wish to move forwards or backwards, the drive motor is switched on and the machine
will begin to move;
► adjust the running speed via the potentiometer (fig. 8, ref. 1);
► once you have reached your destination, engage the parking brake via the pedal (fig. 8,
ref. 12).
WARNING
Never leave the machine unmanned or parked with the parking brake disengaged or the key
inserted in the emergency button. Do not engage the parking brake when the machine is
moving.
Installing and replacing the brushes / drive discs / rollers
WARNING
Do not work if the brushes or drive discs are not perfectly installed.
Brush head (models 60-70-80)
Removing :
► raise the head by pressing the brush up-down button (fig. 8, ref. 5) on the arrow up;
► press the brush release button (fig. 8, ref. 4) for a couple of seconds: when the button is
released, the brushes will be released.
Fitting :
► position the brushes side by side at the front of the machine;
► move forward with the machine until the head is positioned above the brushes and they
are centred;
► press the brush up-down button (fig. 8, ref. 5) on the arrow down and keep it pressed until
the second led of the brush pressure indicator comes on (fig. 8, ref. 8); in this phase the
brush motor may come on and then switch off for a few moments: this is a normal part of
the brush engagement procedure.
WARNING
In particular conditions, the brushes may not engage correctly. In this case the head will
vibrate. The brushes must be disassembled and refitted.
If you wish to use the ABRASIVE DISCS instead of the brushes, they must firstly be fitted on the
drive discs: rest the pad on the drive disc, placing it exactly in the centre, and fix it with the center
lock ring nut. The drive discs must then be fitted on the machine following exactly the same proce -
dure as for the brushes.
WARNING
Fully tighten the drive disc flange via the handle provided in order to prevent the flange
dragging on the ground and damaging the floor.
Roller head (roller models R)
Disassembly:
► press the roller extraction buttons (fig. 11, ref. 4);
21