IP-NET, LLC
VQE1 User Manual V1.3
-
17-
Table 6.3-1 Main Parameter of VQE1
Parameter
Item
Specification
IP Address
Default IP address 192.168.1.2
Submask
Make calculation for source IP
address and submask, and
destination IP address and submask
respectively. If identical result can be
got, the source and destination are in
the same subnet. Otherwise, they are
in different subnet and the
connection should go through
gateway.
Default :255.255.255.0
Network
Management
Gateway IP
Address
If the source and destination are in
different subnet, gateway IP address
should be set.
Default:192.168.1.1
E1
E1
T1
Options are for four E1
Default E1
Encapsulation
Level
1~5
E1 data size
，
N=1~5
，
corresponding to
256
×
Nbyte
（
E1
）、
192
×
Nbyte
（
T1
）
.
The bigger the packet is ,the more
data is encapsulated in each packet,
and the lower overhead it has.
Bandwidth efficiency will be raised
and delay will be increased.
Default :2
Yes
Use IP
Encapsulation
No
Yes
：
IP encapsulation
，
source and
destination IP address should be
set. Bandwidth efficiency will be
reduced
(default)No
：
do not use IP
encapsulation
，
high bandwidth
efficiency
IP TOS
Customers can define IP service
type
，
Default 0x 00
Uplink
Bandwidth
Set full duplex bandwidth for uplink
Ethernet port
，
actual bandwidth
should be higher than this value.
Default 10000Kbps
E1
Management
Destination IP
Remote end IP address
；
4 E1 line IP
addresses can be set separately
Default 192.168.1.3
