IOTAVX PA 3, Инструкция по эксплуатации, Страница: 6 / 20

PA 3 Owner Manual 6
6. Dimmer Link In / Out
The DIMMER LINK OUT jack is used to control the brightness and the brightness of other connected IOTAVX
product.
7. Power switch for 115V/230V
This switch is used to select between 115V or 230V.
8. AC Input
Socket for connecting the supplied IEC Mains Power Cord for connection to mains power
Connections
Before making any connections, read the manuals supplied with your other components. Do not connect the
power cord until you’ve completed and double-checked all connections.
Connection Color Coding:
RCA-type Audio connections are usually color-coded: Red
and White. Use Red plugs to connect right-channel audio
inputs and outputs (typically labeled “R”). Use White plugs to
connect left-channel audio inputs and out-puts (typically labeled “L”).
• Push plugs in all the way to make good connections (loose connections can cause noise
or malfunctions).
• To prevent interference, keep audio and video cables away from power cords and
speaker cables.
Cables and Jacks
Analog
audio cable
(RCA)
This cable carries a Stereo Analogue Audio
Signal. It’s the most common connection
format for Analogue Audio and can be found
on virtually all A/V components.
•
The Red Plug carries the Right-Hand Side
Audio Channel.
•
The White Plug carries the Left-Hand Side
Audio Channel.
Mono mini-
plug
Use the supplied or commercially available
mono mini-plug cable to connect to the
TRIGGER IN / OUT or DIMMER IN OR OUT jacks
on the other device for linked operation. The tip
polarity of the connectors is as shown in the
right.
Speaker Connections
•
Disconnect the power cord from the wall outlet before making or changing any connections.
•
Check the impedance of your speakers. Only connect speakers with an impedance of 8 ohms or more.
• The amplifier’s red speaker terminals are the + (positive) terminals and the black terminals are
the – (negative) terminals. The + side of the speaker cable is marked to make it
distinguishable from the – side of the cable. Connect this marked side to the red +
terminals and the unmarked side is the black terminal.
•
Prepare the speaker cables for connection by stripping
off approximately 10 mm or less of the outer insulation
(no more as this could cause a short circuit). Twist the
wires tightly so that they do not have any frayed or loose
ends.
E
N