IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
WARNING
– Dual Power Supply - Risk of shock hazard even if AC power is OFF.
2.
WARNING
–
Disconnect TBTS (Threaded Body Test Switch) connector before servicing fixture.
3.
WARNING
–
DO NOT mount near a gas or electric heater.
4.
CAUTION
– Before wiring to power supply, turn off electricity at fuse panel or circuit breaker.
5.
CAUTION
– Service by Qualified Personnel only. De-energize before opening.
6.
CAUTION
– DO NOT attempt to service the battery. It is not field replaceable.
7.
CAUTION
– DO NOT use outdoors, in air handler heated outlets, or in hazardous locations. This product is for
use with indoor and damp rated fixtures where the ambient temperature is 0°C minimum to 55°C maximum.
8.
CAUTION
– DO NOT use accessory equipment not recommended by the manufacturer.
9.
CAUTION
– DO NOT use this equipment for other than its intended use.
10
. Consult your local building code for approved wiring or installation.
11.
The LED Emergency Driver must be connected to an un-switched AC power source of 120 to 277 Vac.
12. Product output voltage varies accorting to wattage. Refer to
Illustration 1
for output voltage per model.
13. Equipment should be mounted in a location and at heights where it will not be readily subject to tampering by
unauthorized personnel.
14. Make sure that the branch circuits are derived from a common phase for both normal lighting LED drivers and
the LED Emergency Driver
prior
to installation.
15.
When used with a switched fixture, it is important that the power to the LED Emergency Driver be provided by
an un-switched circuit.
16.
LED Emergency Drivers are for factory and field installation. They are not field serviceable.
17. Allow Battery Packs to charge 24 hrs before initial and full-discharge testing.
18. Emergency lighting system should be tested per all of the required tests and as often as local codes require or
at least quarterly to ensure all components are operational.
19.
Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before
final installation
s.
SAVE THESE INSTRUCTIONS
ILBLP CP HE SD HV
“S” MOUNTING STYLE
HIGH-EFFICIENCY EMERGENCY
LIGHTING EQUIPMENT
FOR LED
INSTRUCTION MANUAL
P.O. BOX 11846 TUCSON, AZ 85734
(520) 294-3292 • FAX (520) 741-2837
www.iotaengineering.com
HIGH EFFICIENCY PERFORMANCE
MEETS CA T20 BATTERY CHARGER
EFFICIENCY STANDARDS
