IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
CAUTION
– This fixture provides more than one power supply output source. To reduce the risk of electrical
shock, disconnect both normal and emergency sources by turning off the AC branch circuit.
2.
CAUTION
– This is a sealed unit. Replace the entire unit when necessary.
3.
DO NOT USE OUTDOORS.
The
ETS-DR
is for use with grounded, UL Listed, indoor fixtures. Not for use in
heated air outlets or hazardous locations.
4. Do not mount near gas or electric heaters.
5. The
ETS-DR
should be mounted in locations and at heights where it will not readily be subjected to tampering
by unauthorized personnel.
6. The
ETS-DR
is compatible with all AC magnetic and electronic ballasts and drivers.
7. The
ETS-DR
is for use in 0-10 volt dimming applications only, and not designed for use with 3-wire dimming or
step dimming ballasts. The maximum current of the dimming circuit must not exceed 100 mA.
8. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
9. Do not use this equipment for other than intended use.
10. Install in accordance with the National Electrical Code and local regulations.
11. Installation and servicing should be performed by qualified personnel.
12. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before
final installation.
SAVE THESE INSTRUCTIONS
ETS-DR
SERIES 924
EMERGENCY LIGHTING
CONTROL DEVICE
INSTRUCTION MANUAL
P.O. BOX 11846 TUCSON, AZ 85734
(520) 294-3292 • FAX (520) 741-2837
www.iotaengineering.com
