screws that move the polar scope in the
appropriate direction.
PLEASE do not over
tighten the setting screws.
c. Adjust azimuth and latitude adjustment
knobs to center the aligning object in the
polar scope.
d. Release the RA Gear Switch and rotate the
mount 180º to bring the RA unit back to the
right side. If you are lucky enough, the
object will stay in center of the polar scope.
Otherwise, repeat Steps 2 and 3 to further
move the object to the center.
e. After few times, the object will stay in center
when the mount is flipped from right to left.
6. Now put the DEC unit back onto the RA axle.
Two of the four hex screws are longer than the
other two. Insert one short one into the TOP
hole inside the DEC unit.
7. Put the DEC unit back onto the RA axle, with
screw holes aligned to the threads on the RA
axle. Gently thread the top screw into the
threaded hole. It should feel very smooth
without any difficulty. Then put two longer
screws into the side holes and gently threaded
it into. Install the last short screw. Then evenly
tighten four screws.
8. Install the polar scope LED with washer and
DEC axle cover.
Short screw
Long screws go into here
Internal use only. Contact iOptron at
if you
have any question.
iOptron Is not responsible for any damage occurred during the
adjustment.
