Inxpect MAGNASPHERE MOTION MSK-101-MM, Руководство по установке

Страница: 11 / 22

Installation and use
MSK-101-MM | Installation instructions v1.7 OCT 2018 | msk-101-mm_instructions_en_us v1.7 | © 2017-2018 Inxpect SpA
11
Before installation
Necessary components and tools
l
Wi-Fi dongle (product code: WSYNC-RJ-
WIFI or WSYNC-RJ-WIFI-US).
l
Android or iOS device with Wi-Fi enabled
and the Inxpect Security application
installed (see "MSK-101-MM" on page 5).
IMPORTANT : to ensure correct
functioning, allow all requested
permissions for the application.
l
Only for barrier applications and if
necessary, adapter for assembly (product
code: MSK-101-BM) (see "Barrier
configuration" on page 7).
l
Two screws up to M4 (No.6) for fastening to
the wall or to the junction box.
l
Screwdriver, wire stripper and fastening
tools not provided.
Prepare for installation
NOTICE : to ensure effective functioning, the
sensor must be installed in the best possible
position and configured correctly. Carefully follow
the instructions below.
Before installing the sensor, perform the following
operations:
1. Define the sensor application type (see
"Applications" on page 5).
2. Define the installation position, considering
possible interferences (see "Interferences" on
page 9).
3. Define the height of installation for the sensor
to obtain the desired field of vision (see "Field
of vision" on page 8).
4. Run a shielded cable with the necessary
conductors from the alarm control unit to
connect the sensor (power supply and relay
outputs).
5. Only for installations with MSK-101-BM
adapter, define the direction of the sensor
(see "Barrier configuration" on page 7).
Warnings
NOTICE : damage to the device. Do not let dust or
water near the sensor during installation.
Install MSK-101-MM
1. Assemble the sensor:
For... And... See...
barrier
applications
with
adapter
MSK-101-
BM sensor
directed
to the
right "Assemble the
sensor with the MSK-
101-BM adapter
(sensor directed to
the right)" on the next
page
barrier
applications
with
adapter
MSK-101-
BM sensor
directed
to the
left "Assemble the
sensor with the MSK-
101-BM adapter
(sensor directed to
the left)" on page 13
all other
cases - "Assemble the
sensor" on the next
page
2. "Connect the sensor to the alarm control unit"
on page 14.
3. "Direct the sensor" on page 15.
4. " Connect the dongle and configure the
sensor" on page 15 .
5. "Fasten the sensor" on page 16.
2