INVT 004G/5R5P-4, Руководство по эксплуатации

Страница: 84 / 178

Function Parameters
80
Function
code
Name Description
Default
value
Modify
potentiometer
E08.44
UP/DOWN
terminals
control
0x00
–0x221
LED ones: frequency control selection
0: UP/DOWN terminals setting valid
1: UP/DOWN terminals setting valid
LED tens: frequency control selection
0: Only valid when E00.06 =0 or E00.07 =0
1: All frequency means are valid
2: When the multi-step are priority, it is invalid to
the multi-step
LED hundreds: action selection when stop
0: Setting valid
1: Valid in the running, clear after stop
2: Valid in the running, clear after receiving the
stop commands
0x000
○
E08.45
UP terminals
frequency
incremental
change rate
0.01
–50.00Hz/s
0.50
Hz/s
○
E08.46
DOWN
terminals
frequency
incremental
change rate
0.01
–50.00 Hz/s
0.50
Hz/s
○
E08.47
Action when
the frequency
setting is off
0x000
–0x111
LED ones: Action selection when power off.
0: Save when power off
1: Clear when power off
LED tens: Action selection when MODBUS set
frequency off
0: Save when power off
1: Clear when power off
LED hundreds: The action selection when other
frequency set frequency off
0: Save when power off
1: Clear when power off
0x000
○
E08.48
High bit of initial
power
consumption
This parameter is used to set the original value of
the power consumption.
The original value of the power consumption
= E08.48 *1000+ E08.49 (kWh)
Setting range of E08.48 : 0
–59999
0
○
E08.49
Low bit of initial
power
0.0
○