involight FOG400, Руководство пользователя

Страница: 14 / 54

13
Part 2. Intended use:
This information sheet contains important information on the safe operation of the device. Ensure that this
information is available to all persons using this device.
Type plate is located on the bottom of the unit.
This device is designed to create artificial mist by evaporation of the nebulised fluid and is intended for
professional use only.
This product is not intended to be used in residential areas. This product is dangerous for
electrical shocks, burns, crashes and personal injury! This product is only approved for connection to AC220-230V,
50Hz alternating voltage and has been designed for indoor use only. Only use the fog machine as described in the
supplied operating instructions. When choosing an installation location, make sure that the unit is not exposed to
excessive heat, moisture, or dust. Make sure there are no cables around. You endanger your own and the safety of
third parties! Make sure that there is always a sufficient amount of mist fluid in the tank. Operation without mist fluid
results in pump damage and overheating of the heating element. Do not operate the unit until after you have
familiarized yourself with its functions. Do not operate the appliance by persons who are not familiar with the
appliance. If the device is to be transported, always empty the tank and use the original packaging in order to avoid
transport damage.
The device may only be used by persons who have sufficient physical, sensory and mental abilities, as well as
appropriate knowledge and experience. Other persons may only use the appliance if they are supervised or
directed by a person responsible for their safety.
A fog machine can work only with the fog fluid developed for the machine. Only use fluid that is specified in the
"Matching accessories" section on the last page. Doing so may result in toxic, harmful gases or damage to the unit.
Do not expose the fog to persons with allergies or respiratory diseases (asthma). Do not create a dense fog in
closed or poorly ventilated rooms.
Any other use as well as use under other operating conditions are considered to be non-intended and can lead to
personal injury or property damage. No liability is assumed for damage resulting from non-intended use.
Part 3. Set-up:
Place the unit on a flat, dry surface. Fill the tank with INVOLIGHT mist liquid or other high-quality water-based mist
fluid. All other fluid types can cause damage to the device. After filling, close the tank with the lid. Connect the unit
to an appropriate power supply. Wait about 3 minutes for the unit to reach operating temperature. The device is
now ready for use. To release the fog, press the corresponding button on the remote control. The device must
never be operated unattended!
Should any liquid fall into the device interior, immediately disconnect the mains plug and consult a specialist.
Your model has a hanger. The unit can be installed on the floor or suspended.
DANGER:
Overhead installed equipment can cause serious injuries when you fall over! If you are in doubt about the
security of a possible installation, DO NOT install the device!
IMPORTANT!
Overhead mounting requires a high degree of experience. This includes knowledge of the load-
bearing capacity, the installation material used and the safety inspections of the material and the projector used,
although the required experience is not limited to this alone. Under no circumstances should you attempt to
perform the installation yourself if you do not have the appropriate qualification. Instead, commission a professional
installer. Incorrect installation may result in personal injury and / or damage to property.
During installation, the provisions of BGV C1 (formerly VBG 70) and DIN 15560 have to be observed! The
installation may only be carried out by authorized specialists!