INVISIBLE FENCE LP4100, Руководство по эксплуатации

Страница: 3 / 8

www.invisiblefence.com 3
CAUTION:
•
To reduce the risk of electrical shock, disconnect power to the
receptacle (outlet) before installing or removing the Surge Protector.
When removing receptacle cover screw, cover may fall across plug pins
or receptacle may
become dislodged.
•
Use only with a duplex receptacle having a center screw.
•
Secure unit in place with screw included with Surge Protector.
Step 1: Turn the power OFF to the outlet that the Surge Protector and Fence
Transmitter will be plugged into.
Step 2: We recommend that, if possible, use the outlet center screw that holds the cover
plate in place to secure the Surge Protector to the outlet. To do this, tape the top of the
cover plate to the wall, and then remove the cover plate center screw. Plug the Surge
Protector into the lower outlet and then secure the cover plate using the longer screw
included with the protector. The screw is for mechanical attachment only and does not
ground the protector. Remove the tape and turn ON the power to the outlet. Be sure to
remove any other protectors and any ground connectors to the transmitter and the
boundary. The Surge Protector gets its ground connection from the AC outlet. Any
additional ground connections will interfere with the protective action and may also
interfere with the operation of the fence transmitter.
Step 3: Strip the insulation from the ends of the boundary wire, uncovering
approximately 3/8-inch. Insert the stripped ends of the boundary transmitter wires into
the two left red connector holes on the bottom of the Surge Protector labeled “Loop”.
Note: There should be one wire in each connector hole. Depress the plastic tab, then
insert the wires and release the tab.