9
Programming the ICT 801, ICT 802, and ICT 810 Transmitters
On first time power up, the LED status indicator lights will display the following default
settings.
Indicator
Default Setting
Loop 1
ON
L1 Freq.
7K
L1 Signal
Outdoor
Mask
Xmit
Loop 2
Off (for 802 model only)
Range
LOW (for 810 model only)
Once the transmitter has been programmed, the settings will remain in the system
memory. To program the transmitter:
1. Press and hold the S1 button for approximately 4 seconds until
a. For ICT 801: The L1 Freq. LED begins to blink.
b. For ICT 802: The Loop 1 LED begins to blink.
c. For ICT 810: The Range LED begins to blink.
2. Release the S1 button.
3. Momentarily press and release the S2 button to toggle between each setting
option.
4. Press and release the S1 button to move to the next setting.
5. Continue until all choices are selected.
6. The cursor LED will stop blinking approximately ten seconds after the buttons are
released, and the transmitter will automatically exit the programming mode.
IMPORTANT: If the transmitter is disconnected from the power source while the status
indicator lights are still blinking, the settings will not be saved to the
system memory.
LED Status Indicator Light:
This is the only visible light from outside of the enclosure when the cover is
closed.
LED Status Indicator Light
Audible Alarm:
There is an audible alarm for
certain alert conditions (See table on page
10). Press and release either the S1 or the S2
button on the circuit board to silence the
alarm. The alarm will re-activate on power-up,
or when exiting set-up mode (if a failure
condition still exists).
