SHAPER
Mod. TI-14
G
Change Speeds and Adjustment of Belt Tension
To change the spindle speed, pull lever nº 5 (fig.3 pg.6) and
loosen the belt. Change the belt position both pulleys, and tighten
the belt by returning the lever to its original position. Adjust belt
tension as belt wears by nuts “G” when necessary.
Micro -Adjustable Fence Assembly
The fence assembly is fastened directly to the table using knobs
“I” at points “R”. Fine adjustment of the infeed and outfeed fence
around the cutter is done by knobs “J”. Once adjusted, the fence
is locked in position by knobs “K”.
Note: Keep the wood guide close to the cutter.
The front and upper flexible metal spring holddown feet, “N” and
“O” should be adjusted to press the wood correctly against the
fence and the table. Top guard “M” comes with the fence and can
be positioned many different ways by holes “L”.
Brake Adjustment
When it is necessary to adjust the brake, loosen nut “P” and
adjust the steel cable by screw “Q” until the assembly is adjusted
properly. Finally, lock the screw by nut “P”.
Table Inserts
Fig. 5
J
N
O
H
I
K
M
L
Fig. 6
P
Q
Fig. 7
R
The machine is equipped with three inserts “R”, which allow the
accomodation of various size cutters. Alignment marks on each
insert are to assure the correct positioning. The inserts can be
locked in place to avoid rotating by turning the lock with an allen
wrench. The largest diameter insert is supplied with four leveling
screws which allow it to be leveled to the table. If an adjustment
is necessary, place a straight edge on the insert and across the
table, then tighten or loosen the four leveling screws until the
correct relationship of the rings to the table is achieved.
NOTE: Cam lock nº 4 (fig.3 pag.6) must be loose when making this adjustment.
Fig. 8
07
