SHAPER
Mod. TI-14
Electrical Connections of the Machine
Each machine is provided with a reference plate that
indicates the requirements of the electrical service
needed for the machine to properly operate. Before
you call a certified electrician to make the wiring
connections, be sure that the voltage and cycle
(phase) stated on this reference plate are the same
as provided in your building.
(Electrician) Remove the electrical box cover and
connect the electrical supply wires to the proper
terminals. Rapidly turn on and off the machine and
then visibly check the rotation direction of the
cutterhead. It should correspond to the direction
indicated on reversing switch. If not, proceed with the
instructions below:
For three-phase machines: invert two wires of the
power source without changing the internal
connections of the machine. See the electrical
diagrams for three-phase on page 08. If further
information is needed or contact Invicta USA.
Loading and unloading
When loading and unloading the machine there
should be no pressure on areas which could affect its
functioning. On figure 01 we show correct procedure
for handling.
Installing the Machine
Place the machine on a level and structurally sound
floor to avoid vibration. On figure 02 we display a
foundation layout for your reference.
CAUTION: The machine comes with a reverse rotation
switch, set it as shown (Clockwise) on the display in the
front panel before testing the rotation direction.
CUTTERHEAD ROTATION DIRECTION
Fig. 01
Fig. 02
02
