2
Thank you for purchasing Inverto’s advanced Unicable II
®
multiswitch and we are certain
it will meet your expectations. Before installing and operating the product, please read
the following instructions and recommendations. We suggest that you keep this manual for
future use.
Warranty
This Unicable II
®
multiswitch is designed for the distribution of satellite and terrestrial television
and radio signals in home installations. The warranty does not apply for products used for
other purposes than those specified herein. The user/installer shall be responsible for any
damage incurred as a result of not using the product according to the instructions in this
manual.
Installation location
The product shall be installed on a wall or other hard inflammable surface.
The product shall be in no case held only with the connected cables.
Place the product in a dry environment where it is not exposed to rain or running water.
Do not install the product close to heat sources or in places exposed to direct sunlight.
Product installation
To distribute the best signal quality across your
installation we recommend connecting the product
inputs and outputs using high-quality coaxial cables
and F-connectors designed for satellite TV distribution.
Use a highly shielded coaxial cables with minimum
shielding of 90dB. If you use wall sockets to loop-
through the STB outputs, make sure the wall sockets
were designed for satellite TV distribution allowing
bidirectional signal propagation.
The satellite input ports can be connected directly to
a Quattro/Wideband LNB (pay attention to the port
designations and the correct position of the LNB type
switch SW1) or cascade to another Multiswitch unit.
The DC-input port of the Multiswitch unit powers the
satellite trunk lines to power the connected LNB. It also
powers the unit’s built-in Terrestrial amplifier as well
as the Terrestrial amplifier of cascaded units. The Trunk
power LED will turn green when the Trunk lines are
powered.
The output ports are powered by the connected STBs
to enable super low power consumption of the unit and allow to power the maximum num-
ber of cascaded switches through a single power supply unit.
If a connected STB is not able to power the port, a power inserter can be utilized*.
* Power Inserter and AC/DC power adapters are not included and can be purchased separately.
Notes:
For optimal performances, satellite loop-through outputs that are not used shall be termi-
nated with 75ohm DC-block terminating resistors. The Terrestrial loop-through output port
152
113
29
Satellite - Loop-through outputs
V/L
H/H
Terrestrial loop
through output
V/L
H/H
Terrestrial input
Trunk
Power
Out 1
Out 2
Out 3
Out 4
DC in
Satellite
A
C
Satellite
B
D
Vertical
Horizontal
Horizontal
Vertical
Horizontal
Vertical
Satellite A or C
Satellite B or D
(S
A
T
A/B
or C/D
)
Unicable II
®
Cascadable switch with
Terrestrial input and 4 Sky
dSCR/SatCR/Legacy
+ equalized Terrestrial outputs
ISKY-UST111-CUO4O-16P
Item: 6097
mode:
Out
dCSS:
Legacy: Steady green
Blinking green
Satellite Inputs (LNB Trunk)
19V
3.0A max.
H/L
Vertical
LNB
type
M a d e i n C h i n a
Quattro
Wideband
2
x
W
id
eb
and
L
N
B
s
10.41 GHz LO
U
ni
ve
rs
al
Quatt
ro
L
N
B
(S
A
T
A/B/C/D
)
V/H
Horizontal
H/L
V/H
D e s i g n e d i n L U
