31
INSTALLATION AND ASSEMBLY
31
iV-Light ventilation device | Installation instructions
►
Pull the panel forwards at the upper edge until you
feel locking hook snap into place.
►
Slide the pre-assembled inner cover into the wall
sleeve.
The inVENTer logo is located at the bottom
right.
►
Level the inner cover base plate using a spirit level.
TIP:
If the inner cover does not sit firmly
enough in the wall sleeve, it can optionally
be screwed onto the interior wall. To do this,
use the 4 corner drill holes in the inner cover
base plate.
The inner cover is installed.
4.9 Installing the inner cover
The installation of the interior termination variants is not part of this documentation!
It can be found in the separate installation instructions for the respective component.
Requirements:
• The thermal accumulator insert has been installed.
!
i
