The OUT1 and OUT2 outputs can work in two modes:
•
PWR mode
– the configuration jumpers set to 2-3 (see the picture below).
In this mode, after the activation of the relay, the output voltage is e.g. 12VDC.
If the reader is powered from 24VDC then the voltage will be 24VDC.
Attention!
If the reader is powered through PoE802.3af and there is no power
supply connected to the power input then the OUT1 and OUT2 outputs
will be
without voltage
.
•
NORMALLY OPEN mode –
the configuration jumpers set to 1-2 (see the picture
below). In this mode, an external power source is required.
User manual RFID IND2
Page
58
of
61
[B01]
Illustration of the output arrangement
(OUT1) for NORMALLY OPEN mode
Illustration of the outputs arrangement
(OUT1 and OUT2) for 12VDC mode
