inventum VVW7040BS Series, Руководство пользователя

Страница: 55 / 112

Problem Possible cause Possible solution
The dishes are not dry. The selected program does not
include drying.
Choose a program that includes
drying. Refer to section
'Programs'
.
The level of rinse aid consumption is
set too low.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
There are rust stains on the dishes. The stainless steel quality of the
dishes is insufficient.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
There is a high level of salt in the
water.
Adjust the level of salt consumption.
Refer to section 'Setting the level of
salt consumption'
.
The cap of the salt reservoir is not
closed correctly.
Make sure that the cap of the salt
reservoir is closed firmly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
There is a problem with the
grounding of the mains supply.
Contact an authorized electrician.
FAULT CODES
The fault codes are shown on the display of the control panel.
Fault code Possible cause Possible solution
F5 There is insufficient water supply.
• Make sure that the water tap is fully open and that
the water supply is not blocked.
• Close the water tap, remove the water inlet hose and
clean the filter of the hose.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
F3 The water supply does not stop.
• Close the water tap.
• Contact the Inventum-servicedienst.
F2 The waste water in the appliance cannot
be discharged.
• Do a check if the drain hose is clogged.
• Do a check if the filters are clogged.
• Reset the program. Refer to section
'Resetting the
program'
.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
F8 The heater has an error. Contact the Inventum-servicedienst.
F1 The safety for water overflow is
activated.
• Disconnect the mains plug and close the water tap.
• Contact the Inventum-servicedienst.
F7 The temperature of the appliance is too
high.
Contact the Inventum-servicedienst.
F6 The heat sensor has an error. Contact the Inventum-servicedienst.
FE There is an electronic error. Contact the Inventum-servicedienst.
English • 55