inventum IVW6034A, Инструкция по эксплуатации

Страница: 27 / 44

Make sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend
that you fit a filter at the beginning of the water supply in your house to avoid any damage to your
appliance because of any contamination (sand, clay, rust, etc.) that might occasionally carried in
through the mains water supply.
• Always use the new water inlet hose supplied with your appliance. If you are using the new water
inlet hose, run water through it for a while before making the connection.
• Connect the water inlet hose directly to to the water inlet tap. The pressure supplied by the tap
should be at a minimum of 0,03 Mpa and at a maximum of 1 Mpa. If the water pressure is above
1 Mpa, a pressure-relief valve should be fitted inbetween.
• After the connections are made, the tap should be turned on fully and checked for water
leakage.
• The appliance is supplied with an double-walled
aquastop
. The system
automatically cuts off the water supply if the water inlet hose starts to leak and the
space between the walls is filled with water. Make sure not to cut into the aquastop
or that it gets twisted or stuck.
• The water drain hose can be connected either directly to a drain pipe with a
minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or crimping
it. The free end of the hose must be at a height between 40 and 100 cm and must not be
immersed in water.
• Close the water tap after each use.
Warning:
When a drain hose longer than 4 m is used, the dishes might remain dirty. In
that case Inventum will not accept responsibility.
• The plug of the appliance must be connected to an earthed socket. Make sure that the voltage
and the frequency values for the current in the home correspond to those on the rating plate.
Inventum is not responsible for damage when using the appliance with a socket that is not
earthed.
• The electrical installation in the home must be provided with a fuse of 16 Amp. The dishwasher
is designed for connection to 220 -240 V ~50 Hz. The appliance should not be plugged in during
positioning. Always use the supplied plug.
• The appliance’s electrical cable should only be replaced by an authorised service or an
authorised electrician. Failure to do so may lead to accidents.
• For safety purposes, always make sure to disconnect the plug when a wash program has
finished. In order not to cause an electric shock, do not unplug when your hands are wet.
CONNECTING TO THE WATER TAP AND DRAINAGE
ELECTRICAL CONNECTION
English •
27