INVENTOR RFI-66B, Руководство пользователя

Страница: 22 / 80

21
Installation of indoor unit
1. Choose a place 2. Install pipes
Where it’s least likely to be affected by outdoor air.
Where free flow of air in and out of the unit will not be blocked.
Where the refrigerant pipe can be easily lead outdoors.
Where conditioned air can reach every corner of the room.
Where there is not too much moisture and can not be easily splashed
with oil.
Where there inflammable gas is not likely to leak or stay.
Choose a solid and even ground.
Leave enough space for installation and maintenance.
Remove air intake grille.
Before wiring and piping, please remove air intake grille.
Remove screw from the grille.
Open the grille by pulling it out by the handle.
Remove chain and take off the whole grille.
3. Install drainage pipe
Make sure drainage pipe is leading to the outdoor side (discharge side.)
Joint drainage pipe with blow moulding drainage pipe and fix with tape from the accessories.
If the drainage pipe needs to be led indoors, please wrap it with insulation material (at least 9mm thick), and then wrap with tape to prevent
air from going into the pipe and cause congealing.
After connecting, check if water can be discharged properly and if there is any leaking.
>30cm
>4cm
>5cm
>10cm
(Pipe side:30cm min.)
Front
>200cm
>10cm
(Pipe side:
30cm min.)
Chain
Screw
Handle
Drainage pipe
19 1
Refrigerant pipe
12 1
Flare-end connection Flare-end connection
Drainage pipe of indoor unit
Blow moulding drainage pipe
Drainage pipe
Wrapping tape