SAFETY AND OPERATING MANUAL
16
202116 2000W Heat Gun
OPERATING INSTRUCTIONS
Note: Before using the tool, read the
instruction book carefully.
Before using the tool
Before starting the job it is advisable to test the
workpiece for the ideal temperature to use. The
description below gives an indication of the likely heat
settings required but always start with the low heat
setting.
The distance between the nozzle and the workpiece will
vary according to the material being worked on but this
should always be at least 50mm (2inch) or more on either
heat setting.
All applications, with the exception of removing paint
from the window frames, can be performed without
using a nozzle; however for best results nozzles are
recommended.
PUTTING INTO OPERATION
1. SWITCHING ON/OFF
Switching on:
To put into operation, slide the switch (5) to position 1, 2
or 3.
Switching off:
To switch off, slide the on/off switch (5) to the stop at
position 0.
After working for a longer time with high temperature,
allow the unit to cool by running in the cold air setting 1
before switching off.
2. THERMO-PROTECTION SWITCH-OFF
When the heater is overloaded (e.g. as a result of re-
stricted air flow), the unit switches it off automatically,
however, the blower continues to run. When the unit has
cooled to operating temperature, the heater is switched
on again.
3. SETTING THE AIR FLOW AND TEMPERATURE
The switch (5) can be set to three blower steps. Suitable
air flow and temperature combinations can be selected
according to the applications.
Содержание 202116
