Invenco G6 OPT 6500x, Руководство по установке

Страница: 17 / 40

Invenco Group Limited Proprietary & Confidential
4.4 Replacement of a G5 Product
The G6 OPT is designed to fit into the existing cut-out created for the G5 OPT to allow an easy
upgrade.
To simplify this process a Retrofit Kit is available for either side-mounting or top/bottom-mounting,
depending on the model of G5 OPT being replaced.
Before beginning, determine whether the existing G5 OPT is:

side-mounted (with a motorised card reader), or

top/bottom-mounted (with a manual card reader).
4.4.1 Power Supply Considerations
The G5 OPT was typically installed with one of the following power supplies:

Meanwell S-100-24

Franmar S-100F-24
Either of these power supplies is quite capable of driving a single G6 OPT.
Some installations may have used a single supply to drive two G5 OPTs, in which case care needs
to be paid to the maximum internal temperature of the enclosure, to avoid the power supply
becoming overloaded after de-rating for temperature.
The G6 OPT draws considerably more power than the older terminals and while two terminals will
likely operate from a single supply, Invenco does not guarantee error-free operation when coupling
2 OPTs to a single PSU unless the PSU is rated to handle the power demands of both OPTs and
validated against the full test scenarios. Note that the G6 has been certified using a one-to-one
ratio of OPT to PSU. All other configurations are not certified.
De-rating curves for typical G5 OPT (left) and recommended G6 OPT (right) power supplies.