little loose and you have to make sure that
when the three Torx screws are put back in
the board is sandwiched between the upper
and lower half moon mouldings and held in
place by pressure from the fascia. A piece
of double-sided tape applied to the back of
the board may make is easier.
25.
Gently feed the ribbon cable under the flat
base moulding until the half moon moulding
is in back in place.
26.
Refit the three Torx screws and tighten
them down all the while checking that the
board is engaged on the mushroom pegs.
27.
Inspect your work.
28.
Now tighten down the four cross head
screws in the base moulding.
29.
Check that the BC7A controller is located
over the pegs and that all pegs are present
in the holes in the BC7A board.
30.
Check that both volume buttons move and
you can feel them depress. If they do not
depress then the BC7A is not sitting down
correctly over the pegs so you have to
investigate the cause and rectify.
31.
Align the back edge of the Button board
with the edge of the aperture in the dock
cradle moulding. Gently lower the button
panel ensuring that the 4 pins on the
connector engage properly in the connector.
It may be necessary to gently jiggle the
button panel unil you feel the pins slide in.
32.
Apply power to the dock. You should hear
a series of beeps indicating that the dock is
powered up and ready to be used.
Invebo BC7A User Instructions
The BC7A is certified to be compliant with Bluetooth
5.0. It also supports any source device that complies
with Bluetooth version 2.0 and above.
Note: Indicator LEDS are only visible if Invebo
cradle support is fitted
Power on Auto Power Up: When the mains power
is applied the dock will power up with a series of
tones in rising note and the RED power LED will
illuminate.
THE DOCK WILL REMAIN IN LOW-POWER
STANDBY MODE UNTIL MUSIC IS REQUIRED
Manually Powering Down the Dock: If the red
standby LED is annoying then the dock can be
completely powered down by pressing and holding
both volume buttons until a series of tones falling in
pitch are heard. The Red LED extinguishes and the
dock is fully powered off.
Manually Powering Up the Dock: When the dock
is powered down, hold the + volume button down
until you hear a series of tones rising in pitch.
Release the button. The dock powers up and the
unit is now in standby. The red LED illuminates.
Auto Standby: The dock will automatically place
itself in Standby if no audio has been played for a
few minutes.
LED Indicator Modes
NOTE THE INDICATOR LEDS WILL ONLY BE
VISIBLE IF THE CRADLE SUPPORT UPGRADE
IS FITTED
RED Power status LED Illuminates when powered
up and ready to play or perform Bluetooth
operations.
Blue LED Off: BC7A is not in pairing mode and not
connected to another Bluetooth Device.
Blue LED Fast Flash: BC7A has entered the
pairing process.
Blue LED Short flash every 3 seconds: A source
device is connected but is not streaming
Blue LED Permanently Illuminated: A Bluetooth
device is connected and is currently streaming
audio.
Docking and Playing an iPod
Any Apple 30 Pin iPod or iPhone that supports USB
charge Mode* will charge and play when plugged
into the 30-pin socket. The docks can be controlled
as before using the standard infrared remote control,
the volume buttons and the controls on the
iPod/IPhone.
*
(USB Charge Mode is an Apple term and does not mean that
there is an USB charging socket – it refers to the USB signals
present on the 30-pin iPod dock socket)
