SECTION 6—FRONT RIGGINGS
Part No 1143195
17
Van Seat
SECTION 6—FRONT RIGGINGS
WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
Installing/Removing Front Riggings
CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE:
For
this
procedure,
refer
to
FIGURE 6.1.
Installing
1. If
necessary,
remove
the
footboard.
Refer
to
owner’s
manual
shipped
with
the
wheelchair.
2. Turn
front
rigging
to
the
side
(open
footplate
is
perpendicular
to
wheelchair)
and
position
mounting
holes
in
the
front
rigging
hinge
plates
with
hinge
pins
on
the
wheelchair
frame.
3. Install
the
front
rigging
hinge
plates
onto
the
hinge
pins
on
the
wheelchair
frame.
FIGURE 6.1
Installing/Removing Front
Riggings
4. Push
the
front
rigging
towards
the
inside
of
the
wheelchair
until
it
locks
into
place.
NOTE:
The
footplate
will
be
on
the
inside
of
the
wheelchair
when
locked
in
place.
5. Repeat
STEPS
1
‐
4
for
opposite
side
of
wheelchair.
Telescoping Front
Rigging Support
Front Rigging
Release Lever
Front Rigging
Hinge Plate
Hinge Pins