Invacare Rea Spirea4 NG, Руководство пользователя

Страница: 16 / 40

16
1.
B
A
1.
2.
2
1. Adjusting the seat depth
Fold the chair slightly by lifting the seat upwards.
The front part of the seat is attached with Velcro
straps from the back part of the seat. Pull up the
Velcro strap and adjust by pulling the side of the
seat forwards or backwards in the rails on the side
tubes. Check that the adjustment is even on both
sides.
When you have finished, fold the chair right out
again and then attach the Velcro strap in the back
part of the seat.
2. Adjusting the shape
Pull back the seat’s upper section so that the adjus-
table Velcro straps are visible. Use these straps to
adjust the seat. Always have a cushion on the seat
when testing if the shape is correct.
The depth of this seat can also be adjusted in the
same way as the fixed seat.
SEAT
BACK REST
2. Loosen the screws (B) on the reverse side of the
back tubes with an Allen key. Now it is possible
to raise and lower the back. Tighten the screws
again.
When the adjustment is complete, secure
with new plastic ties on the back of the back
upholstery if you have a fixed back upholstery.
Tighten them properly!
Adjusting the back rest height
1. Cut off both plastic ties (A) at the bottom of the
back upholstery with a pair of scissors. Then fold
the chair slightly by lifting the seat upwards. Or
loosen and fold the back upholstery forwards
Tool: 5 mm Allen key