Invacare Rea Focus 150, Руководство пользователя

Страница: 14 / 56

Rea® Focus™
A
1. Remove the armrests and the seat cushion.
2. Loosen the two screws
A
.
3. Adjust the seat width.
4. Re-tighten the screws.
If the wheelchair is equipped with Flip-up armrests, the
following also needs to be done:
B
1. Loosen the screws B .
2. Re-tighten both screws
A
and the screws
B
5 mm allen key
3.13 Adjusting the seat
A
B
C
1. Loosen the screw
A
.
2. Adjust the seat front B to the desired position.
Only adjust the seat front within the marked
area
C
. Max adjustment 5 cm
3. Re-tighten the screws again.
4. Repeat the procedure on the opposite side if necessary.
The seat front B can also be removed completely
if necessary.
Screwdriver
3.14 Leg rests
WARNING!
Risk of injury
– Never lift the wheelchair by the footrest
supports or leg rests.
CAUTION!
Risk of pinching or crushing fingers
There are swing mechanisms where you could
trap your fingers.
– Be careful when using, swinging, disassembling
or adjusting these mechanisms.
IMPORTANT!
Risk of damage to the leg rest mechanism
– Do not place anything heavy, or let children sit
on the leg rest.
3.14.1 Swing away leg rests
Swinging outwards
1. Activate the release lever
A
and swing the leg rests
to the outside.
Swinging forwards
1. Swing the leg rest forwards until it engages.
Unhinging
1. Activate the release lever
A
.
2. Pull the leg rest upwards.
Hinging
1. Hinge the leg rest on the front of the frame and swing it
forwards until it engages.
14 1431580-C