Invacare Rea Assist, Руководство пользователя

Страница: 11 / 35

REA® ASSIST 11
1.
2.
10 cm
A
3.
B
Adjustments
SEAT
The seat depth of the chair can easily be adjusted
to provide good support. The width between the
armrests and the height of the armrests can also be
adjusted.
1. Depth adjustment
Loosen the catches of the legrests and swing
them outwards towards the sides. Then loosen
the two screws (A) using an Allen key. Note that
the screws must only be loosened a few turns,
not unscrewed completely. Lift up the seat cush-
ion slightly. Take hold of the front edge of the
seat frame and pull the frame and cushion to the
new position. Then retighten both screws (A). To
retain the stability of the chair when the cushion
is moved forwards by a large amount, extension
tubes are available as an accessory to the castors
2. Seat depth
To obtain a precise setting for the seat depth,
there is a cm scale on the frontal seatplate ena-
bling you to set the correct seat depth easily. You
also get a reminder that the risk of tipping for-
wards increases if you increase the seat depth.
Tools: 5 mm Allen key.
3. Seat width adjustment of the width
between the armrests.
Loosen the Allen screw (B), pull the armrest to
the right position and then re-tighten the screw.
Note that the screw is placed under the seat
on the front of the tube by the right-hand
armrest and on the back of the tube by the
left-hand armrest.
Smaller width for seat pad
When the seat width is small, i.e. when the arm-
rest attachments are push in, we recommend a
seat cushion that is smaller than the one supplied
as standard.
Tools: 5 mm Allen Key